Table of Contents
Advertisement
2-5
Creating Virtual Network Configurations Offline
2-5-2
Procedure
5. Enter a name for the Master Unit, and then click the Finish Button to finish adding
the Master.
Adding Slaves
1. Select the component model from the component list DTM (CompoNet) Tab Page,
and drag and drop it in the Network Configuration Window.
2. Enter the name and node address, and click the Finish Button.
3. The slave is now registered.
Drag and drop
Note
If a slave that is not allowed is added when the Master Unit is in Communications Mode
0 (a Bit Slave or a Word Slave at node address 8 or higher), the dialog box shown be-
low will be displayed requesting that the user check the communications mode.
Check the communications mode of the Master Unit, and if the number of slaves being
used is within the allowable Node Address Range, select Don't show this message
again and click the OK Button.
2-43
Advertisement
Table of Contents
