Omron CX-INTEGRATOR - V2.3 REV 02-2009 Operation Manual page 184

3-2-10 Transferring Routing Tables to a Network PLC through a Direct Serial Connection
10. Step 9 completes the transfer of the routing tables to PLC2.
Repeat steps 4 through 9, and perform the same procedure to transfer the routing
tables to PLC3, PLC4, and PLC5.
Verifying the Connected PLC
The output area in the lower-right corner of the PLC Routing Table Window displays
information about the currently connected PLC.
The output window is displayed if the PLC is connected online.
Also, the output window can be displayed by selecting Window – Output in the PLC
Routing Table Window.
Display Example (When the Target PLC is Changed)
Unit No. relayed by directly connected PLC
PLC with direct
serial connection
Note: These values are not displayed when the PLC is connected through a direct
serial connection.
Note The routing tables cannot be transferred to a PLC in another network layer. When
transferring to a PLC in a different network layer, directly connect the CX-Integrator to
a PLC in that network and transfer the routing tables.
Destination
network
(See note.)
Destination PLC information
3-2 Setting the Routing Tables
Destination
CPU Unit of
node address
destination node
(See note.)
(See note.)
3-31