Table of Contents
Advertisement
6-12 Downloading the Network Configuration/Device Parameters to Devices
Note
Parameters cannot be downloaded to the master through the Network Configuration
Window unless the CPU Unit is in Program Mode. If the message Device state conflict.
Going to change PLC Mode. OK? is displayed, check the operation mode of the CPU
Unit.
6-12-3
Resetting the Device
Component - Reset
To enable the new settings, use the following procedure to reset the network device.
1. Place the CX-Integrator online.
2. Select the device in the Network Configuration Window.
3. Select Device - Reset.
The following confirmation dialog box will be displayed.
4. Click the Yes Button.
The progress window will be displayed and the devices will be reset.
The new settings will be valid after the devices have been reset.
Note
When the devices are reset, communications errors will temporarily occur. For this
reason, do not reset the devices while the master-side PLC (CPU Unit) is operating.
6-12-3 Resetting the Device
6-55
Advertisement
Table of Contents
