Table of Contents
Advertisement
CX-Integrator (or a CX-Integrator for another personal computer) to start
the Routing Table Component and then changing or removing a routing
table for the target PLC (either a local network table or a relay network
table).
Note
If routing tables are transferred to the PLC from a Programming Device, the CPU Bus
Unit will be reset. The Unit is reset in order to read and enable the routing tables that
were transferred. Before executing the routing table transfer, verify that no equipment
will be damaged and it is safe for the CPU Bus Unit to be reset.
Note
The routing tables cannot be transferred to another network layer. When transferring
to a different network layer, directly connect the CX-Integrator to a PLC in that
network and transfer the routing tables.
3-2-5 Transferring Routing Tables to a Directly Connected PLC
3-2 Setting the Routing Tables
3-25
Advertisement
Table of Contents
