Omron CX-INTEGRATOR - V2.3 REV 02-2009 Operation Manual page 141

2-6 Manipulating Component Parameters
2-6-2 Procedure
Note 2: Set other settings in the PLC Setup using the CX-Programmer PLC Setup settings.
Example for a CompoWay/F Slave Component.
Right-click a CompoWay/F slave component and select Edit Parameters. The Edit
Parameter Dialog Box will be displayed.
Downloading and Uploading Parameters from Actual Components
Uploading and Downloading Component Parameters for Individual Components
Downloading
To download component parameters set on the computer to the actual component,
select Transfer [PC to Unit] in the Edit Parameter Dialog Box. The parameters will be
downloaded to the actual component.
Depending on the Unit, it may be necessary to restart in order to make the downloaded
Note
settings effective. Click the OK Button in the verification dialog box, and restart the
Unit.
Uploading
To upload component parameters from the actual component to the computer, select
Transfer [Unit to PC] in the Edit Parameter Dialog Box. The parameters will be uploaded
from the actual component.
Comparing
To compare the component parameters set on the computer to those in the actual
component, and select Compare in the Edit Parameter Dialog Box. The parameters set
for the component on the computer will be compared with those set in the actual
component.
When downloading parameters to the actual component, the unit version of the
Note
component on the computer and the unit version of the actual component must be the
same.
If the following message is displayed when attempting to download parameters, the unit
version of the component on the computer is different from the unit version of the actual
component.
Use the following procedure to change the unit version of the component on the
computer to the same unit version as the actual component and then download the
parameters.
1. Right-click the PLC in the Network Window and select Compare and Change Unit
Version from the pop-up menu.
2-50