Table of Contents
Advertisement
General Tab Page
Function Choice
Registration
Table
Software Setting
Transfer[Unit to PC]
Transfer[PC to Unit]
Compare
Name
Communications
When this option is selected, all input data for the
Error
Input
Data
Slave Unit will be cleared to zeros if a
Zero Clear
communications error occurs in the Slave Unit. This
will prevent operation that is triggered by IN data in
Slave Units that have a communication error.
I/O Communication
When this option is selected, the following will apply.
• When the Master (PLC) is turned ON, remote I/O
Manual Startup
Mode
• Remote I/O communications will start when the
Message Disable
When this option is selected, the following functions
Setting
will be disabled.
• Sending explicit messages to Slave Units.
• Receiving explicit messages from the CPU Unit at
Edit Registration
When this option is selected, the Registration Table
Table
Tab Page will be displayed.
Edit Software
When this option is selected, the Software Setting
Setting Table
Table Tab Page will be displayed.
Parameters from components on the network will be
uploaded to the CX-Integrator.
Parameters set with the CX-Integrator will be
downloaded to the components on the network.
Compares the parameters set with the CX-Integrator
with the settings of the component parameters on the
network.
7-6 Editing Master Unit Parameters
7-6-1 Master Unit Parameter Settings
Function
communications will not be started.
Remote I/O Communications Start Switch (setting
parameter bit 00) is turned ON in memory.
the Master Unit.
7-19
Advertisement
Table of Contents
