Setting Slave Parameters; Editing Slave Parameters - Omron CX-INTEGRATOR - V2.3 REV 02-2009 Operation Manual

6-2 Setting Slave Parameters

6-2-1 Editing Slave Parameters

6-2 Setting Slave Parameters
6-2-1 Editing Slave Parameters
Component - Parameter - Edit
The parameters of some slaves can be set. However, doing so may cause the I/O size
to change. Because of this, the slave parameters must all be set before setting the
master's parameters.
EDS files are required for setting the parameters. If there are no EDS files available,
they must be obtained from the device manufacturer.
Note Slaves must be added to the Network Configuration Window to edit the parameters.
Refer to 2-5 Creating Virtual Network Configurations Offline for information on creating
a virtual network.
To edit the parameters, use the following procedure.
1. Select the device.
2. Select Component - Parameter -Edit.
3. The following warning dialog box will be displayed if there are no editable
parameters.
Slaves for which this message is displayed do not require parameter setting.
The following dialog box will be displayed if editable parameters exist.
6-4