Device Monitor Screen; Contrast And Brightness Adjustment - Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Contrast and Brightness Adjustment

Reference: The Programming Console Screen is supported only by the NT21, NT31,

5-13 Device Monitor Screen

Reference: These screen numbers can be referred by the following functions:

5-14 Contrast and Brightness Adjustment

104
PT
NT11S/NT11, NT20, NT20S, NT600S,
NT30, NT30C, NT620S, NT620C, NT625C
NT21, NT31, NT31C, NT631, NT631C
NT31C, NT631, and NT631C.
These are system-defined screens and cannot be created or viewed in NTST.
Application manager will not list out these screens. Screens available are:
Screen No.
9021
9022
9023
(1) Touch switch Switch screen
(2) Bit memory table Switch screen function
(3) Bit memory table Alarm function
These screens can only be view on PT if the communication method is NT link. If
communication method is host link, it would not be possible to switch to these
screens.
This is a system-defined screen and cannot be created or viewed on NTST. The
application manager will not list this screen. Contrast and Brightness Adjustment
is used for tuning the contrast and brightness of the PT screen without the need
to disconnect from the PLC.
The screen number designated is 9030.
PT models that support this requirement are as follows:
NT31-V2 (System Ver3.1),
NT31C-V2 (System Ver3.1),
NT631C-V2 (System Ver3.1). (NT631C-ST141j only)
This screen can be accessed using the following functions:
(1) Touch switch – Switch screen
(2) Bit memory table – Switch screen function
(3) Bit memory table – Alarm function
DAC Function Name
I/O Monitor
DM Monitor
Error Monitor
Section 5-14
Screen No.
None
9020
NT31/631/31C/631C-V
2 Function Name
Registration Monitor
Continuous Monitor
Error Log