Self-Test Results Messages - Paradyne HotWire 7974 User Manual

Self-Test Results Messages

7970-A2-GB20-00
The results of the last power-up or reset self-test appear in the middle column of
the System and Test Status screen.
Table 5-2. Self-Test Results Messages
Message What Message Indicates
Passed No errors were detected.
CPU Failed The CPU failed internal testing.
Device Failed One or more of the unit's integrated circuit
chips failed device-level testing.
DSX-1 Failed The unit failed to loop data on the DTE
Sync Port Failed interface circuit.
G.703 Failed
Memory Failed The unit failed memory verification.
FPGA Failed A failure in the FPGA was detected.
DataPath Failed The unit failed to loop data between the
DSX-1 Port and the DSL loop.
Failure xxxxxxxx An internal failure occurred. (xxxxxxxx
represents an 8-digit hexadecimal failure
code for use by service personnel.)
August 1999
Monitoring the Unit
What To Do
1. Reset the unit and
try again. try again
2. Call your service
re resentative for representative for
assistance.
Record the failure code
and contact your
service representative.
5-5