7. Monitoring and Troubleshooting
Self-Test Results Messages
The results of the last power-up or reset self-test appear in the middle column of
the System and Test Status screen.
Table 7-2.
7-6
Self-Test Results Messages
Message
What Message Indicates
CPU Failed
The CPU failed internal
testing.
DataPath Failed
The unit failed to loop data
between the DSX-1 Port and
the DSL loop.
Device Failed
One or more of the unit's
integrated circuit chips failed
device-level testing.
DSX-1 Failed
The unit failed to loop data on
Sync Port Failed
the DTE interface circuit.
G.703 Failed
Failure xxxxxxxx
An internal failure occurred.
(xxxxxxxx represents an
8-digit hexadecimal failure
code for use by service
personnel.)
FPGA Download
The download of a Field
Failed
Programmable Gate Array
(FPGA) failed.
PLD Failed
A failure in a Programmable
Logic Device (PLD) was
detected.
Memory Failed
The unit failed memory
verification.
Passed
No errors were detected.
December 2001
What To Do
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
Record the failure code and
contact your service
representative.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
No action is needed.
7900-A2-GB21-20