Switching Between Screen Work Areas; H Ending An Ati Session - Paradyne HotWire 7974 User Manual

Using the Asynchronous Terminal Interface

Switching Between Screen Work Areas

"
Î
Î
Ending an ATI Session
"
2-8
Select Ctrl-a to switch between the two screen work areas to perform all screen
functions.
Procedure
To access the screen function area below the dotted line:
1. Press Ctrl-a to switch from the screen area to the screen function key area
below the dotted line.
2. Select either the function's designated (underlined) character or press the
Tab key until you reach the desired function key.
Example:
To save the current screen, type s or S ( Save).
3. Press Enter.
4. To return to the screen area above the dotted line, press Ctrl-a again.
main/config/network
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate:
DSL Line Rate:
Payload Rate:
Circuit Identifier:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Use the Exit function key from any screen to terminate the session.
Procedure
To end a session with the asynchronous terminal interface:
1. Press Ctrl-a to go to the screen function key area below the dotted line.
2. Save changes if required. A confirmation message appears if you have made
but not saved changes to your configuration.
3. Tab to Exit (or type e or E) and press Enter.
August 1999
NETWORK INTERFACE OPTIONS
Hotwire
Model: 79xx
–3db
1E–6
Disable
1552 Kbps
1536 Kbps
Î Î
Î Î
Clear
MainMenu Exit
7970-A2-GB20-00