Paradyne HotWire 7974 User Manual page 122

Configuration Option Tables
Table A-6. Communication Port Options (3 of 3)
Login Required (Terminal Use Only)
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies if an ID and password are required to access the asynchronous terminal
interface on the communication port. Login IDs are created with a password and access
Creating a Login in Chapter 8, Security .
level. Refer to
Enable – Login ID and password are required to access the asynchronous terminal
interface.
Disable – No Login ID and password are required to access the asynchronous terminal
interface.
Port Access Level (Terminal Use Only)
Possible Settings: Administrator, Operator
Default Setting: Administrator
Specifies the highest level of access allowed when accessing an ATI session through a
Telnet session.
Administrator – This is the higher access level, permitting full control of the unit.
Access level is determined by the Login ID. If Telnet Login Required is disabled, the
session access level is Administrator.
Operator – This is the lower access level, permitting read-only access to status and
configuration screens.
Inactivity Timeout (Terminal Use Only)
Possible Settings: Enable, Disable
Default Setting: Disable
Provides automatic logoff of a Telnet session.
Enable – The terminal session terminates automatically after the Disconnect Time.
Disable – A terminal session will not be closed due to inactivity.
Disconnect Time (Minutes) (Terminal Use Only)
Possible Settings: 1 – 60
Default Setting: 5
Number of minutes of inactivity before the session terminates automatically. Timeout is
based on no keyboard activity.
H
Disconnect Time (minutes) appears when Inactivity Timeout is enabled.
1 to 60 – The Telnet session is closed after the selected number of minutes.
A-16
August 1999 7970-A2-GB20-00