Self-Test Results Messages - Paradyne 7974 User Manual

Self-Test Results Messages

7900-A2-GB21-00
The results of the last power-up or reset self-test appear in the middle column of
the System and Test Status screen.
Table 7-2. Self-Test Results Messages
Message What Message Indicates
CPU Failed The CPU failed internal testing.
DataPath Failed The unit failed to loop data between the
DSX-1 Port and the DSL loop.
Device Failed One or more of the unit's integrated circuit
chips failed device-level testing.
DSX-1 Failed The unit failed to loop data on the DTE
Sync Port Failed interface circuit.
G.703 Failed
Failure xxxxxxxx An internal failure occurred. (xxxxxxxx
represents an 8-digit hexadecimal failure
code for use by service personnel.)
FPGA Download The download of a Field Programmable
Failed Gate Array (FPGA) failed.
PLD Failed A failure in a Programmable Logic Device
(PLD) was detected.
Memory Failed The unit failed memory verification.
Passed No errors were detected.
August 2000
Monitoring and Troubleshooting
What To Do
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
Record the failure code
and contact your
service representative.
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
1. Reset the unit and
try again.
2. Call your service
representative for
assistance.
7-5