Using The Asynchronous Terminal Interface; User Interface Access; Communication Port Settings - Paradyne HotWire 7974 User Manual

Using the Asynchronous Terminal
Interface

User Interface Access

Communication Port Settings

7970-A2-GB20-00
You can communicate with the Hotwire 79xx Standalone Termination Unit with an
asynchronous terminal interface (ATI) using one of the following methods:
H
Direct connection through the COM port of the standalone unit or through the
serial port of the DSLAM MCC.
H
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one terminal interface session can be active at a time, and another
user's session cannot be forced to end. To automatically log out a user due to
inactivity, enable the Inactivity Timeout option (see Table A-7,
Options, in Appendix A, Configuration Option Tables ).
Security can limit ATI access several ways. To limit user access or set up login
IDs, refer to Chapter 8, Security
Ensure that the device you connect communicates using these settings:
H
Data rate set to 9.6 kbps.
H
Character length set to 8.
H
Parity set to None.
H
Stop Bits set to 1.
August 1999
.
2
Telnet Session
2-1