Paradyne HotWire 7974 User Manual page 114

Configuration Option Tables
Table A-3. Synchronous Data Port Options – Models 7975 and 7985 (2 of 3)
Invert Transmit Clock
Possible Settings: Disable, Enable
Default Setting: Disable
Specifies whether the clock supplied by the termination unit on the TXC interchange
circuit DB (CCITT 114) is phase inverted with respect to the Transmitted Data
interchange circuit BA (CCITT 103). This configuration option is useful when long cable
lengths between the termination unit and the DTE are causing data errors.
Disable – Indicates TXC supplied by the termination unit on this port is not phase
inverted.
Enable – Indicates TXC supplied by the termination unit on this port is phase inverted.
Send All Ones on Data Port Not Ready
Possible Settings: Both, Disable, DTR, RTS
Default Setting: Both
Specifies the conditions on the data port that determine when valid data is not being
sent from the DTE. When this condition is detected, all ones are sent to the network.
Both – Monitors both DTR and RTS. If either is interrupted, all ones are sent to the
network.
Disable – Disables the monitoring of interchange circuits from the DTE connected to
the synchronous data port.
DTR – Monitors the DTE Ready interchange circuit CD (CCITT 108/1/2). When DTR is
interrupted, all ones are sent to the network.
RTS – Monitors the Request-to-Send interchange circuit CA (CCITT 105). When RTS is
interrupted, all ones are sent to the network.
Action on Network LOS Alarm
Possible Settings: Halt, None
Default Setting: Halt
Specifies the action taken on the synchronous data port when an LOS (Loss Of Signal)
alarm is received on the network interface.
Halt – Stops the transmission of data on the data port and disables the data port when
an LOS alarm is received on the network interface. When LOS alarms are received, all
ones are sent on the Received Data interchange circuit BB (CCITT 104). The
Clear-to-Send interchange circuit CB (CCITT 106) is interrupted.
None – Makes the data port unaffected by LOS alarms received on the network
interface.
Network Initiated Data Channel Loopback
Possible Settings: Disable, Enable
Default Setting: Disable
Allows the initiation and termination of a Data Channel Loopback (DCLB) by the receipt
of a DCLB-actuate sequence or DCLB-release sequence from the network or far-end
device.
Disable – Ignores the DCLB-actuate and DCLB-release sequences for this port.
Enable – DCLB-actuate and DCLB-release sequences are recognized for this port.
A-8
August 1999 7970-A2-GB20-00