Table of Contents
Advertisement
Using Your Modem
Using the Escape Sequence —
Switching Between Data Mode
and Online Command Mode
To enter online Command mode while in Data mode, enter the
following sequence. For more information on Command and
Data modes, see page 3-2.
TYPE:
NOTE:
The value of the escape sequence character (+++) and
the idle time required before and after an escape
sequence are determined by the S2 and S12 registers. If
you want to change these values, refer to the descriptions
of these S-Registers in Chapter 4.
To return to Data mode from online Command mode, use the
O command. Enter the following command:
TYPE:
PRESS: Enter
Viewing, Selecting, and Saving
Modem Settings
Modem settings determine how the modem functions. These
settings are known as configuration options and are stored in
two permanent memory areas, User Profile 0 and
User Profile 1.
When the modem is initially turned on, the contents of one of the
two memory areas are retrieved into a volatile work area of
memory known as the Active User Profile. (The &Y command
determines which of the two user profiles will be retrieved.) If
you should make changes to the modem's configuration and
then turn the modem off without saving those changes, they are
lost forever.
+++
The modem enters online Command mode and
responds with an OK.
ATO
Issue 1 November 1994
3-9
Advertisement
Table of Contents
