2. Using the Asynchronous Terminal Interface
Switching Between Screen Work Areas
Select Ctrl-a to switch between the two screen work areas to perform all screen
functions.
Procedure
To access the screen function area below the dotted line:
Ending an ATI Session
Use the Exit function key from any screen to terminate the session.
Procedure
To end a session with the asynchronous terminal interface:
2-8
1. Press Ctrl-a to switch from the screen area to the function key and message
area below the dotted line.
2. Select either the function's designated (underlined) character or press the Tab
key until you reach the desired function key.
Example:
To save the current screen, type s or S ( Save).
3. Press Enter.
4. To return to the screen area above the dotted line, press Ctrl-a again.
main/config/network
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate:
DSL Line Rate:
EIA-530 Payload Rate
Transmit Attenuation
Peer IP Address:
Circuit Identifier:
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
1. Press Ctrl-a to go to the function key and message area below the dotted line.
2. Save changes if required. A confirmation message appears if you have made
but not saved changes to your configuration.
3. Tab to Exit (or type e or E) and press Enter.
December 2001
NETWORK INTERFACE OPTIONS
–3db
1E–5
Disable
1552 kbps
1536 kbps
0dB
111.255.255.000
Model: 797x
Clear
Clear
MainMenu
Exit
7900-A2-GB21-20