(11) Setting the loop length
(12) Setting the folding length (on the loop grasping side)
(13) Setting the folding length (on the cutter side)
(Setting range : 50.0 to 80.0 mm)
Input the length of the loop after its both ends have been folded.
* If the DIP switch SW7 located on the upper side of the side face of the panel is
set to OFF, this pictograph will not be displayed.
(Setting range : 10.0 to 20.0 mm)
Input the folding length on the far side of the operator.
* If the DIP switch SW7 located on the upper side of the side face of the panel is
set to OFF, this pictograph will not be displayed.
(Setting range : 10.0 to 20.0 mm)
Input the folding length on the near side of the operator.
* If the DIP switch SW7 located on the upper side of the side face of the panel is
set to OFF, this pictograph will not be displayed.
– 25 –