(4) Changing the length of bartacking
(5) Changing the value of belt loop width
(6) Changing the loop guide
❶ ❶
❹ ❹
❺ ❺
❷ ❷
❶ ❶
❸ ❸
❺ ❺
Change the 1D bartacking length data on the setting
screen.
Change the data of loop width of 1F in the setting
screen.
1) Move fork ❸ to the underside of presser foot ❹
under the step mode.
2) Loosen loop guide setscrews ❶ . Move loop
guide ❷ until its claw portion slightly comes in
contact with the loop. Then, tighten setscrews ❶ .
* When changing the thickness of the belt loop,
adjust the loop guide ❷ by loosening the loop
guide setscrews ❶ and rotating the loop guide
height adjustment screw ❺ . This may cause
sewing failures such as stitch skipping.
If the adjustment range is exceeded, especially
for thin fabrics, cut off the tip of the included loop
guide.
– 38 –
❷ ❷