Adjustment Of The Belt Loop Without Splice - JUKI MOL-254N Instruction Manual

5. Adjustment of the belt loop without splice

＊ Belt Loop ＊
P=1
Key [1] = level
Adjustment
Key [R] = Return
＊ Belt Loop ＊
[7] = Feed
[9] = set
[R] = Return
A belt loop without splice, when setting in the step 6) is not performed, cannot distinguish the
thickness from the thickness of normal loop, and the error (AL-56) may occur during sewing.
Be sure to perform the aforementioned setting for the belt loop without splice.
1) Flashing [1I] or [1J] in the setting screen, press
the splice input screen.
2) Press the ten key [1].
level (0)
3) Set a belt loop and keep pressing the ten key [7] of the loop
level (30) feed button.
(For approximately two seconds)
4) Press the ten key [9] to set the data.
5) Press the
6) Here, enter with the ten key the numeric value as much as
approximately 4-times of the data value of [1J] in the state of
flashing [1I] (thickness of splice section) data.
Example)
– 41 –
key to return to the setting screen.
Enter 82 → 96.
key to enter