Table of Contents
Advertisement
2. Adjusting the width of belt loops
(1) Changing the binder
(2) Adjusting the loop gathering claw
❹ ❹
❷ ❷
(3) Adjusting the cross cut position
❷
B
A
❶
❷
❶ ❶
❷ ❷
❸ ❸
❶
❸
Loop center
Fig. 1
– 37 –
Loosen screws ❶ and adjust the position of loop
width guide ❷ so that a clearance of 1 mm (as thick
as the splice section) is provided between the belt
loop and the binder. Then, tighten screws ❶ .
1) Loosen setscrews ❶ . Press the belt loop
against loop gathering claw B ❷ .
2) Press loop gathering claws A ❸ and ❹ against
the loop and tighten setscrews ❶ .
Loosen main body setscrews ❶ , turn adjustment
screw ❷ and move the setscrews in the direction A
or B to adjust the position of the main body so that
the cut belt loop becomes the loop center as shown
in Fig. 1.
Pull the belt loop splice detector lever ❸ to front side,
and the necessary amount of the loop can be fed.
Further, pressing the standard screen key
press ten key 3. Then, the loop presser unit releases
the loop. Again, pressing the standard screen key
, press the ten key 3. Then, the loop can be cut.
Use this function when performing the adjustment.
The aforementioned operations can be
actuated only when the setting screen is
displayed.
,
Advertisement
Table of Contents
