7. Replacing the loop folding shaft
WARNING
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt
start of the sewing machine.
❸
❸
1) Turn OFF the power switch and the air.
2) Loosen folding shaft presser spring setscrews ❶ so that folding shaft presser springs ❷ do not push up
the folding shafts.
3) Loosen the screws of joints ❸ and draw out the air tubes from joints ❸ .
Shaft A
❹ ❺ ❺
❹
4) Loosen folding shaft setscrew ❹ .
5) Move the folding shaft in the direction of the arrow to draw it out from driving gear shaft ❺ .
6) Take care not to mix up the front and rear loop folding shafts when installing them. Aligning setscrew ❹
with the flat part of gear shaft ❺ , press the loop folding shaft against the shaft A and tighten setscrew ❹ .
7) Insert the air tubes you have drawn out back to the respective joints ❸ and tighten the screws.
8) Tighten setscrews ❶ at the position where the tip of folding shaft presser spring ❷ does not come in con-
tact with the inner surface of folding shaft bushing ❻ .
Front folding shaft
Rear folding shaft
– 43 –
Setscrew
Flat part
Setscrew
Flat part
❶ ❶
❶ ❶
❷ ❷
❻ ❻
❷ ❷