Confirmation Of Needle Entry Point - JUKI MOL-254N Instruction Manual

Count UP screen
When the counter is in the state of count-up after sewing, the following screen is displayed.
* When setting 1st hook and 2nd hook individually, the part only to which count-up is performed is dis-
played.
* Be sure to use the counter since the moving mechanism is provided on front side (1st hook).
After turning OFF the power switch and replacing the bobbin on the displayed side, turn ON the power
and press the set ready switch. Then, count-up screen is displayed.
Here, press the reset switch

3. Confirmation of needle entry point

◦ When the sewing screen is displayed, jump feed operation of presser foot only can be performed by
pressing the left cursor key
Use this function when confirming the needle entry point or the like.
Traveling backward is performed with the
In addition, when jump feed operation screen is displayed, the presser foot moves up or down by press-
ing the needle threading switch
When turning ON the needle threading switch
der the presser foot.
◦ The screen returns to the sewing screen by pressing the
and clear the counter.
or the right cursor key
key, and traveling forward with the
.
, be sure not to place your hand or the like un-
– 20 –
Count-up screen
.
button.
key.