(8) Moving the loop feeding unit
❹
❸
(9) Changing the fullness unit
❹
❹
❸ ❸
(10) Fullness gathering amount on the panel
❶
❷
❺ ❺
❻ ❻
❷ ❷
❶ ❶
– 36 –
Loosen screw ❶ and ❷ , move knife unit guide rail
❸ to align the engraved line to scale ❹ .
Loosen setscrews ❹ . Move fullness lever ❶ to the
right and left (
) to position it almost at the cen-
ter between loop receiver (front) ❷ and loop receiver
(rear) ❸ . Then, tighten setscrews ❹ .
1) Change the data value of <1H> to an appropriate
value.
2) Loosen setscrews ❻ of fullness stopper ❺ .
Move the fullness stopper up and down (
in accordance with the fullness gathering amount
<1H>. Then, tighten setscrews ❻ .
)