[Ci] Setting Of Waiting Time When The Supply Slide Base Travels Backward To The End; [Cj] Function Of Individual Operation Of The Machine Head; [Ck] Setting Of The Number Of Revolutions Of The Machine Head Motor; [Cl] Setting Of The Machine Head Motor Operating Time - JUKI MOL-254N Instruction Manual

(9) [CI] Setting of waiting time when the supply slide base travels backward to the end

(10) [CJ] Function of individual operation of the machine head

(11) [CK] Setting of the number of revolutions of the machine head motor

(12) [CL] Setting of the machine head motor operating time

Standard setting time is 0.03s.
The recommended value for the MOL-254N (Model setting: CO=01) is 0.1s.
Length of time to wait for calming down of damping of the jumping movement when
the folding shaft is changed over to up position by means of the change-over of
cam.
If the shaft goes to clamp the belt loop before calming down of damping of the
jumping movement, the shaft may not be able to securely clamp the belt loop.
The setting time affects the cycle time when the belt loop is clamped at the first
time, and set back is performed.
When sewing is continuously performed, it takes time until the belt loop is drawn out
and this setting time does not affects the cycle time.
When clamping mistake of the belt loop occurs even if the setting time is
extended, slippage of the height of fork is considered. Check the install-
ing dimension of the components.
Driving of the machine drive motor only is performed.
The respective modes, M-0, M-1 and M-2 can be selected.
M-0 : Individual operation of machine head is prohibited. (Normal operation is prior.)
M-1 : Machine head drive motor runs at the specified speed.
M-2 : Machine head drive motor runs at the specified speed and stop of setting time
is repeated.
Start button for starting operation is the starting switch of the upper DIP SW No. 8
located on the right side of the operation box panel for safety.
Number of revolutions of the machine head motor when operating [CJ] is set.
This is the number of revolutions at the time of start, and the number of revolutions
can be changed through the operation box panel when the machine head starts up.
This is not displayed unless M-1 or M2 of [CJ] setting is set.
Operating time of the machine head when operating [CJ] is set. This setting per-
forms operation and stop based on the number of revolutions set in [CK] and stop
time of set value in [CM].
Operation or stop is performed based on [CM] set value.
This is not displayed unless M-2 of [CJ] setting is set.
The machine head operates within the setting time regardless of the
number of stitches.
– 53 –