Draining Waste Oil - JUKI MOL-254N Instruction Manual

❶
❷
❹

14. Draining waste oil

2) Front side
Loosen setscrew ❶ in the thread trimming arm
and adjust by moving it in the direction of arrow.
3) Rear side
Remove rubber cap ❷ located on the machine
bed side and adjust by loosening setscrews ❸ in
the thread trimming connection plate.
❸
❷
4) Loosen setscrew ❻ and adjust so that a clear-
❺
ance of 0.8 mm is provided between needle hole
guide ❹ and counter knife ❺ .
(Same adjustment procedure for both front side
and rear side)
❻
When polyethylene oiler ❶ becomes filled with oil,
remove polyethylene oiler ❶ and drain the oil.
❶
– 49 –