Under-Table Mounting Type Bobbin Thread Winder - JUKI MOL-254N Instruction Manual

2. Under-table mounting type bobbin thread winder

Name
Bobbin thread winder (asm.)
❷ ❷
❶ ❶
LED 1,2,3,4
"+", "-", "P",
Emergency
"<", ">" key
stop
Threading Diagram
Part number
40228356
[Installation method]
Insert bobbin thread winder mounting rod ❶ into
hole ❷ in the bobbin thread winder and secure with
a nut.
Start
– 65 –
[Winding the bobbin thread]
1. Button description
1) Red button: emergency stop, press this button
for 2 seconds will be reset.
2) Green button: Start
3) "P" key: function key, Hold down "P" key for 2
seconds to enter parameter setting, after setting
is finished, press this key again for 2 seconds to
keep parameter.
4) "+" key: numbers from 0 to 9
5) "-" key: numbers from 9 to 0
6) "<" key: turn left
7) ">" key: turn right
2. Indicator light
1) Parameter indicator light
2) Production failure indicator light
3) Stop indicator light
4) Work indicator light
3. Parameter setting
Hold down "P" key for 2 seconds to enter the param-
eter setting inter face.
A: The thread length setting is 0 to 99.9 meters
B: Compensate for 0 to 9.9 meters
C: The bobbin calculate to thread length 0 to 99.9
meters
D: Motor speed: F1 (fast), F2 (medium), F3 (slow)
E: LED lamp brightness: H0 (OFF), H1 (darkest),
H2, H3, H4, H5 (brightest)