(7) Fine adjustment of bartacking position
Sewing position may slightly move when a loop is changed to the other loop of different width or to the other
loop of different material.
Use this setting when compensating the correction amount at this time.
(8) Fullness setting
Changeover of standard to fullness alternatively (*1)
Fullness gathering amount
(Setting range : 0 to 9.9 mm)
*1 Not displayed if fullness device (refer to
on the lower side of the panel) has been stopped.
Set value (fullness gathering amount)
Loop of double input value is supplied in surplus.
Be sure to perform trial stitching, however, since input value may be different from the expected value in ac-
cordance with waist and thickness of the loop or center-to-center distance between bartacks.
Moves to the right as much as the set value.
Moves to the left as much as the set value.
◦ Moving direction changes with the press of the screen change-over key
Standard sewing
Fullness sewing
"VI-6. Setting of DIP switches" P.30
– 23 –
.
for the DIP switch SW3