Table of Contents
Advertisement
(3) Belt feeding amount
(4) Setting of splice cutting (front)
(5) Setting of splice cutting (rear)
Range of
effective loop
Setting of the length when belt loop is picked out (unit : mm)
Folding amount of belt loop in the rear side changes.
The longer the belt loop is picked out, the more the folding amount increases.
The value and the value of folding length are not the same since there is
a difference in mechanical adjustment value.
When setting the folding amount of belt loop in the front side, adjust the loop feed-
ing unit. (Refer to
"VII-1-(8) Moving the loop feeding unit"
At this time, be sure to re-turn ON the power after the adjustment.
If you change this value, the folding length will be changed. Check [1L] and [1M].
This setting inputs the distance to conduct as a defective loop the front side from
the position where the top end of splice is confirmed. (Unit : mm)
Splice section at the top end of splice is gradually swollen, and the accuracy of de-
tection varies in accordance with the material of loop.
This setting is to compensate the error of accuracy of detection.
In addition, it may be necessary to adjust the error in accordance with the width of
belt loop.
This setting inputs the distance from the rear end of splice section to the position to
cut the loop. (Unit : mm)
The loop should be cut in the slight rear of splice section since the cross cut is ap-
plied to the loop. Otherwise, the splice section gets mixed with the loop.
The standard set value of [BD] or [BE] value is 10mm.
Range to be conducted as splice section
BD set value
BE set value
– 27 –
P.36.)
Cross cut section
Advertisement
Table of Contents
