6. Changing the straight cutting
(1) Changing the knife position
90°
(2) Changing the DIP switch
❷
❶
❷
❶
SW6
❶
1) Stop the air supply.
2) Loosen setscrew ❷ in clamp collar ❶ .
3) Adjust so that the moving knife is at right angle
against the loop.
4) Fit clamp collar ❶ to the bushing on the rod side
of cylinder, and fix it with setscrew ❷ .
Remove cover ❶ located on the right side of opera-
tion box, and turn ON SW 6 of DIP switches located
on the lower side of the right side.
"VI-6. Setting of DIP switches"
(Refer to
– 42 –
P.30.)