Table of Contents
Advertisement
(6) Setting of wiper operating time (Unit : sec)
(7) X-axis origin compensation of the sewing machine presser (unit : mm)
(8) Y-axis origin compensation of the sewing machine presser (Unit : mm)
(9) Fork origin compensation
Setting of wiper operating time is performed. (Unit : sec.)
Change the operating time when the operating time is short and thread cannot be
wiped.
Input the change with the ten key. (Standard setting : 0.06)
This adjustment is performed when the position of the presser and needle is shifted
due to unexpected accident or the like.
(This adjustment is not used unless replacement of X-Y table, or adjustment of X-Y
table sensor slit is performed.)
Move the X-axis origin to the right or left.
Enter the adjustment screen with the screen change-over key
Adjust with the ten keys following instructions in the screen.
This adjustment is performed when the position of the presser and needle is shifted
due to unexpected accident or the like.
(This adjustment is not used unless replacement of X-Y table, or adjustment of X-Y
table sensor slit is performed.)
Lower the Y-axis origin.
Enter the adjustment screen with the screen change-over key
Adjust with the ten keys following instructions in the screen.
This setting performs compensation of the position where the fork catches the belt
loop.
Left direction makes the fork travel forward, and right direction makes it travel back-
ward.
Changeover of front/rear direction can be performed with the screen change-over
key
.
Data of compensation amount is memorized in ROM. It is recommended, however,
to take a memo of the data for preparing the worst.
– 28 –
.
.
Advertisement
Table of Contents
