Connecting The Power Cable - Eizo SCD 19102 Instructions For Use Manual

Connecting

5.5 Connecting the power cable

The connection panel for the signal cables and power supply is located on the back of the
monitor. All signal inputs can be connected simultaneously.
Prerequisite
• The monitor is installed in the ceiling suspension or wall mount unit, or on a stand.
Procedure
1. Using a suitable tool, remove the connection panel cover.
2. Connect the signal cables to the monitor.
3. Tighten the screws to secure the signal cables.
4. Place the cover back on the connection panel.
5.5 Connecting the power cable
DANGER
Connecting to line power
• The device is designed for line power with a protective earth conductor.
• To avoid risk of electric shock, this device must only be connected to line power with a
protective earth conductor.
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective earth conductor.
CAUTION
Risk of damage to the device
• Only use power cables or connection cables with protective earth conductor and appli-
ance plug according to DIN 49547, IEC 60320 (max. cable length 3 m, cable type e.g.
H05VV-F 3 x 1.0 mm
spective country.
The power cable socket is located on the back of the monitor. The monitor's power supply is
connected using an appliance plug.
• Open and close the connection panel using an appropriate tool.
• Insert the appliance plug of the power cable into the line power socket.
• The power cable can be secured using a cable grip.
20
2
). The cable must comply with the safety regulations of the re-
SCD 19102
Instructions for Use, 06/2022