Installing The Base And Cable - Eizo SCD 19102 Instructions For Use Manual

5.6 Installing the base and cable

CAUTION
Do not use screws of excessive length
Screws which are too long can damage mechanical and electronic components of the de-
vice.
1. Attach the connecting cable before installing the stand on the monitor.
2. Slightly tighten the screws on the mounting plate.
3. First insert two screws into the bottom two drilled holes of the stand.
4. Then insert the remaining screws into the top two drilled holes.
5. Slowly lower the monitor.
SCD 19102
Instructions for Use, 06/2022
Connecting
5.6 Installing the base and cable
21