Table of Contents
Advertisement
2-2. Connecting the signal cable
NOTE
Be sure that the power switches of both the PC and the monitor are OFF.
1.
Plug the signal cable into the connector at the rear of the monitor
and the other end of the cable into the video connector on the PC.
After connecting, secure the connection with the screw-in fasteners.
Signal Cable (FD-C39 enclosed)
NOTE
Only TMDS DATA1 (Green) of video signal data is displayed.
The monitor is not compatible with a color graphics board.
2.
Plug the power cord into the power connector on the rear of the
monitor.
3.
Lead the power cord and signal cable into the cable holder at rear of
the monitor.
NOTE
When housing the cables into the cable holder, lead them to the cable entrance
side and pinch the projection to open the cable entrance.
The cables are recommended to lead with slight sag for the smooth motion of
the stand.
Signal Cable
FD-C39
Connector
Video Output Connector /
DVI
2. CABLE CONNECTION
English
Power Cord
PC
Monochrome digital
graphics board
13
Advertisement
Table of Contents
