Start-up
6.4 Menu functions
Main menu
36
Function
Adjustment /
setting range
Signal setting
Switch loop
1 - 20
Default: 1
Tolerance factor
1 - 20
Default: 1
Signal (only for
RGB
analog signal)
Monochrome
Default: RGB
Description
The following four parameters are
of relevance for this tool:
•
H frequency
•
V frequency
•
V total
•
Interlaced/non Interlaced
If one of these parameters
changes, the monitor treats it as a
timing change and initiates resyn-
chronization via "Auto in progress".
To prevent this from happening as
a result of each and every minor
signal disturbance, the value repre-
senting the permissible number of
faulty or changed borders must be
increased in the case of unstable
signal sources.
Note: The higher the tab setting,
the longer it will take for a desired
timing change to occur (delayed by
a number of milliseconds).
This tool only considers the H
and V frequencies.
An increase in the tab value results
in a larger tolerance band being
defined. Minor frequency fluctua-
tions within this range will not result
in resynchronization ("Auto in
progress").
Switch over signal between b/w
and color operation
•
If a monochrome signal arrives,
it is green on the color monitor.
•
To obtain correct b/w images,
set the "Signal" parameter to
"Monochrome".
Instructions for Use, 06/2022
SCD 19102