Connecting The Power Cable - Eizo CuratOR LX490W Instructions For Use Manual

Procedure
1. Using a suitable tool, remove the connection panel cover.
2. Connect the signal cables to the monitor.
Note: All signal inputs can be connected simultaneously.
3. Tighten the screws to secure the signal cables.
4. Place the cover back on the connection panel.

5.5 Connecting the power cable

DANGER
Connecting to line power
• The device is designed for line power with a grounded neutral conductor.
• To avoid risk of electric shock, this device must only be connected to line power with a
protective conductor.
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective conductor.
CAUTION
• Only use power cables or device connection cables with protective conductors and ap-
pliance plugs according to DIN 49 547, IEC 60320 (max. length 3 m). Furthermore, the
cable must adhere to all local safety regulations applicable to the specific country in
which the monitor is used.
• Device fuses should only be replaced in repair centers or by service personnel.
• Note for North America: Molded power plugs must comply with the requirements for
hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.
CAUTION
Opening the connector panel cover
Only service may open the connector panel cover. Patients must not be present when the
cover is open.
CAUTION
Connector
Connectors may only be plugged in or removed by Service when the device is switched
off.
CuratOR LX490W
Instructions for Use, 06/2017
Connecting
5.5 Connecting the power cable
23