Setting The Image Geometry; Setting The Brightness And Contrast - Eizo SCD 19102 Instructions For Use Manual

Note
Energy saving (Power Management)
The monitor supports various energy saving settings, called Power Management (PM).
When PM is active, the monitor backlight switches off automatically for example, if the
monitor is without a video signal for an extended period.
Also observe the operating system manufacturer's instructions regarding power manage-
ment settings.

6.8.2 Setting the image geometry

The monitor automatically recognizes the standard used, and has preprogrammed set-up
values for each standard. However, depending on the graphics card used, it may still be
necessary to align and size the picture for the selected standard.

6.8.3 Setting the brightness and contrast

The brightness and contrast must be adjusted for the respective graphics card (different out-
put levels) in the system on site.
Note
Brightness and contrast can only be set accurately using a photometer.
Note
Fine adjustment for analog or digital inputs
• Fine adjustment for analog inputs should only be carried out via the two analog ports
(15-pin Sub-D and DVI-I).
• The digital input (DVI-D) does not require a fine adjustment since the signal display is
always optimum. With a fine adjustment, it is possible that gray scales are not dis-
played.
Procedure
• Use the SMPTE test pattern.
• Adjust the brightness so that image sections with 5 % and 0 % gray value still visibly
contrast.
• Adjust the contrast so that image sections with 95 % and 100 % gray value still visibly
contrast. To adapt the luminosity to the ambient lighting, adjust the backlight brightness.
Please note that the factory-set brightness is then no longer maintained.
SCD 19102
Instructions for Use, 06/2022
Start-up
6.8 System settings
49