Carburetor Synchronization - Honda V65 MAGNA 1985 Manual

MAINTENANCE
/jJ
VALVE ADJUSTING WRENCH
07908-MB00100
REAR CYLINDER HEAD COVER
\
CAST MARK
Recheck the valve clearance.
Rotate the crankshaft 270
0
clockwise to align the
T2-4 mark With the crankcase
mating
surfaces and
check the valve clearances 'or No.2 cylinder uSing
NO.1 cylinder procedure.
Adjust if necessary using the procedure for No. 1
cylinder.
Rotate the crankshaft 90° clockwise to align the
Tl-3 mark with the crankcase mating surface and
check the valve clearance for
No.3
cylinder.
Adjust using the procedures for NO.1 cylinder.
Rotate the crankshaft 270
0
clockwise to align the
T2-4 mark with the crankcase mating surface and
check the valve clearance for No.4 cylinder.
Adjust if necessary using the procedure for No.1
cylinder,
Install the removed parts, except the radiator cap,
In
the reverse order of-disassembly.
Be sure the cast mark inside the rear cylinder head
cover faces the front and the tabs of the front cylin·
der head cover face the rear.
17le lock m.as will come loose ifnor tightened
to the
cOn'ect
torque value.
Check the engine oil level.
Turn the radiator valve to "OPEN" (see page 3-12),
Fill and bleed the cooling system (page 6-3).
Hold the adjusting screws and tighten the lock nuts.
TORQUE: 21-25 N·m (2.1-2.5 kg-m, 15-18 ft-Ib)
CAUTION:
Install the radiator cap.
CARBURETOR SYNCHRONIZATION
NOTE
Synchronize the carburetors with the engine
at norma) operating temperature, transmission
in neutral, and motorcycle on the center stand.
Remove the plugs from the No.1, 2, 3 and 4 cylin-
der head ports and install the vacuum gauge adap·
ters.
Connect the vacuum gauges.
NO, 2 CYLINDER HEAD PORT PLUG
3-14