Honda V65 MAGNA 1985 Manual page 222

Table of Contents

Advertisement

DRIVE TRAIN
Place the pinion assembly into the gear housing.
Drive the pinion assembly into the geltr case until
pinion retainer threads can engage with the case
threads.
Apply gear oil to the
a·ring
and threads on the
pinion retainer. Install the O-ring guide tool.
Screw in the pinion retainer to press the pinion
bearing in place, then tighten
it
to the specified
torque.
TORQUE;
100-120 N·m (10-12 kg-m, 72-87 ft.Jb)
RING GEAR ASSEMBLY
Install the original spacer onto the ring gear.
NOTE;
If the gear set, pinion bearing, ring gear bear-
ing and/or gear case are replaced, install a 2.0
mm thick spacer.
RING GEAR SPACER
RETAINER WRENCH
07910-4630100
RING GEAR BEARING
..=
/
Place a new ring gear bearing on the ring gear shaft.
Place the old bearing on top of it. Then, drive the
new bearing onto the shaft with the old bearing and
attachment. Then remove the old bearing.
14-12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vf11doc 1985

Table of Contents