Honda V65 MAGNA 1985 Manual page 161

CYLINDER HEADIVALVE
INDEX DOTS
Align the index dots on the front cylinder cam
sprockets
with
the top of the cylinder head (viewed
from the left side of the engine).
Place the cam chain on the sprockets.
Slide the sprockets onto the camshaft flanges. and
install the sprocket bolts in the exposed holes
(rotate the crankshaft clockwise a little if neces-
sary).
Check mat the sprocket index dots align at T2-4.
Unlade the cam chain tensioner.
Front/Rear Cylinders
Check the front·to-rear cylirn:ler camshaft timing
as follows.
NOTE: INDEX LINES
When the Tl-3 mark aligns with the rear
crankcase mating surface, the index lines
on all cam sprockets should align with the
top of the cylinder heads.
All camshaft marks will either face up or
down.
Turn the crankshaft as required to install the
remaining sprocket bolts 8t.1I four camshafts.
Tighten the camshaft sprocket bolts to the specified
torque.
TORQUE: 18-20 N·m 11.8-2.0 kg-rn, 13-14 ft·lbl
INDEX LINES
Tighten the tensioner base bolts securelv.
TENSIONER BASE
10-23