Clean the crankcase mating surfaces.
Ii
Apply liquid sealant to the mating surface of the
lower and upper Cflnkcase.
CAUTION:
Do not apply sealant
to
the
OTto
near the
mtlin bearing!.
DO NOT COAT THESE AREAS.
Install the dowel pin.
CRANKCASE
I
.
Assemble the crankcase halves, aligning the shift
fork claws with the gears.
Tighten the bolts to the specified torque values in
the sequence shown.
TORQUE VALVES:
10
mm
bolt: 43--47 N·m
14.3-4.7 kg-m. 31-34fHbl
8
mm
bolt: 21-25 N·m
(2.1-2.5 kit"'. 15-18
ft~b)
6
mm
bolt: 10-14
N-m
(1.0-1.4 kg-m, 7-10 ft-Ibl
Tighten the bolts in a crisscross pattern and in 2-3
steps.
11-5