Honda V65 MAGNA 1985 Manual page 202

TRANSMISSION
If the difference in measurements exceeds the
limit, it indicates that the bearing is not installed
squarely. Inspect the bearings and reinstall if neees-
"'Y.
If backlash is excessive, replace the countenhaft
gear adjustment shim with
iii
thinner one.
II the backlash is too small, replaC1l the counter-
shaft $him with a thicker one.
Backlash is changed by about 0.06-0.07 mm
(0.002-0.003
in)
when thickness of the shim is
changed by 0.10 mm 10.004 in).
COUNTERSHAFT!OUTPUT DRIVE GEAR
ADJUSTMENT SHIMS:
0.40 mm 10.016 in)
0.45 mm (0.018 in)
0.50
mm
10.020
in)
0.55 mm 10.022 in)
0.60 mm 10.024 in)
13-16
SHIMS