Honda V65 MAGNA 1985 Manual page 229

Make sure the universal joint is in line with the
driveshaft. Then insert the drivershaft into the
swing arm aligning its splines with the outer shaft
splines. Keep the gear case and damper case together
or damper oil will leak out.
Secure the gear case to the swing arm with the three
attaching nuts. To ease axle installation, do not
tighten the gear case nuts until after the axle is
installed.
Install the rear wheel (page 16·8).
Tighten the axle nut.
TORQUE:
85-105 N·m 18.5-10.5 kg-m, 61-76 ft-Ibl
Tighten the three final gear case attaching nuts.
TORQUE; 45-70 N·m 14.5-7.0 k9"m.
33-51
ft·lb)
Tighten the axle pinch bolt.
TORQUE: 20-30 N·m (2.0-3.0 kg.m. 14-22 ft-Ibl
Install the shock absorber (page 16-' 31.
Make sure that the drain bolt is tightened.
Remove the oil filler cap and pour in the specified
amount of recommended oil.
'83:
RECOMMENDED OIL: Hypoid Gear Oil API, GL·S
Above SoC (41°F): SAE
#90
Below SoC (41°F): SAE
#80
OIL CAPACITY:·
170 cc (S.7 ozl Dry
130 cc (4.4 oz) Refill after draining
After
'83:
RECOMMENDED OIL: Hypoid Gear oil
SAE #80
OIL CAPACITY:
lS0 cc (5.1 oz) Dry
130 cc (4.4 oz) Retill after draining
DRIVE TRAIN
FINAL GEAR CASE
ATIACHING NUTS
'ft.,..__._...
OIL FILLER CAP
OIL DRAIN BOLT
14-19