Honda V65 MAGNA 1985 Manual page 47

Remove the radiator mounting bolts.
Slide the radiator 10 the right and suspend it from the
handlebar with a piece of wire.
Remove the ignition coils with their bracket and
remove the insulator cover.
Remove the front and rear cylinder head cover bolts
and both cylinder head covers.
INSPECTION
RamOlla the alternator cover.
Turn the flywheel clockwise until the "T1-3" mark
aligns with the crankcase mating surfaces in com-
pression stroke.
Make sure that the No.1 piston is at TOC (Top
Dead Cenler) on the compression stroke.
Insert the camshaft holder as shown and tighten
it.
Check the valve clearance for the No. 1 cylinder
using two feeler gauges for each pair of valves.
VALVE CLEARANCE liN, EX);
0.15
mm
(0.006
in)
If adjustment is necessary, loosen the lock nuts and
turn the adjusting screws until there is a slight drag
on both feeler gauges. Both feeler gauges should
remain inserted during adjustment.
MAINTENANCE
RADIATOR
CYLINDER HEAD
COVER
CAMSHAFT HOLDER
07979-MKJOOOO
3-13