Honda V65 MAGNA 1985 Manual page 243

Remove the bolt caps and the handlebar cover.
Remolle the handlebar upper holder bolts.
Remove the handlebar upper holders and the center
handlebar.
FRONT WHEEL/SUSPENSION
HANDLEBAR COVER CENTER HANDLEBAR
INSTALLATION
Place the center handlebar onto the lower holder,
aligning its punch mark with the upper surface of
the lower holder.
Place the upper holder onto the lower holder with
its punch mark facing forward.
Tighten the forward bolts first, then tighten the
rear bolts.
TORQUE: 40-50 N·m 14.0-5.0 kg·m. 29-36 ft-Ibl
Install the bolt caps and handlebar cover.
Install the right and left handlebars into the center
handlebar.
Install the handlebar set screws.
Apply grease to the handlebar pinch bolts.
Tighten the pinch bolts after aligning the punch
marks with the slits on the center handlebar.
TORQUE; 25-30 N·m (2.5-3.0 kg·m. 18-22 ft·lb)
HANDLEBAR COVER
SET SCREW
----
PINCH BOLT
PUNCH MARK
15-13