Honda V65 MAGNA 1985 Manual page 343

TURN SIGNAL RELAY INSPECTION
NOTE:
The turn signal light does not come on unless
the turn signal switch is in neutra1.
Remove the right frame side cover.
Connect a jumper wire between the blue/black wire
of the turn signal relay and ground.
Turn the ignition switch ON.
The turn signa! light should come on.
If the light does not come on, check the source
voltage at the gray wire terminal while grounding
the blue/black wire of the turn signal relay coupler.
If there is no volt8ge, replace the turn signal relay.
POSITION LIGHT RELAY INSPECTION
SWITCHES
TURN SIGNAL RELAY
TURN SIGNAL RELAY
GRAY
WIRE
BLUE/BLACK
'1!J~~
WIRE
Remove the coupler box cover (page 15-3).
Remove the position light relay.
Check for continuity between A and B terminals.
Connect a fully charged 12V battery to the relay
terminals as shown.
The position light relay is normal if there is no
continuity with the battery connected.
POSITION LIGHT RELAY
~ B
li~--
21-15