Table of Contents
Advertisement
Innova 2100-IQ, 3100/3100-IQ, 4100/4100-IQ Cardiovascular Imaging System Pre-Installation Manual
GE Healthcare
3 Structural Requirements
3.1 Room Size
For Room size dimensions, refer to
For additional details, refer to
3.2 Door Size Requirements
Minimum door sizes also apply to hallways and elevators. For additional details, refer to
Chapter 7, Section 1,
3.2.1 Door Height
The minimum door height (to accommodate Innova positioner on its dolly) is 1.980 m (78 in).
If the height is limited to 2 m (79 in), you will need a fall over cabinet.
3.2.2 Door Width
The minimum door width needed (to accommodate the Innova LC shipping dolly) is:
•
1.165 m (46 in) with protective side rail,
•
1.096 m (43 in) with one protective side rail removed on site.
NOTE:
Door widths are based on a straight–in approach requiring a 2.44 m (96 in) wide corridor.
Calculations need to be made for accommodation of equipment through narrower corridors.
3.3 Floor
3.3.1 General Vascular GEMS Policy
GEMS's Customer is responsible for the structural analysis and mounting of the base
plates. If GEMS is forced to mount the base plate, the LCT must hire a structural
engineer to design and approve the mounting method and provide GEMS with an
engineering report.
The floor level cannot exceed a general levelness of 5 mm (0.2 in) for any 2 meters (79 in).
The floor slabs on which the equipment is to be installed must have a levelness of
1 mm (0.04 in) per meter (40 in). Position of baseplates and table basement depends
on the type of installation. The two types of installation are given in
The Table baseplate or the System baseplate are mandatory to install the table
(patient support).
The Table must never be installed on grade.
58
Chapter 4, Section 2,
Chapter 4, Section 1,
Shipping Information.
Direction 5314528-2-1EN, Revision 1
Room Layout Drawings.
Room Layout Considerations.
3 Structural Requirements
Illustration 3-2
.
Advertisement
Table of Contents
