SMC Networks D-MH1AD Series Operation Manual page 56

Copy ready status
コピー準備状態
Press the SET button to start copying.
Sending/
Receiving
Copy
completed
(Copy from)
Press the
SET button.
Successive copying is possible
The copy ready status is maintained
even if the power supply is turned off.
コピー準備状態
When exiting the copy function,
press the UP and DOWN buttons
simultaneously for 1 second or
longer.
[F97] Copy function setting completed
: When the copy to sensor monitor displays [Er13], it indicates a sending and receiving error of the copy function. Press the UP and
DOWN buttons simultaneously for 1 second or longer to return to measurement mode. Then check the wiring and specifications
and retry the copy function.
: Copying may not be executed depending on the timing. In that case try again.
: The set value of SP1 to SP3, W_1 to W_3, and H_1 to H_3 will not be copied. The set value that was set before copying will be
maintained. Be sure to set the above values according to the actual operation of each analogue ASW.
The copy ready status is maintained even if the power supply is
turned off.
Copy from sensor monitor
Main display: Red
Main display: Red
-55-
Copy to pressure sensor monitor
Main display:
Green
•When completed
normally:
Main display:
Green
•In abnormal state:
Main display: Red
(Copy to)
When
completed
normally, press
the SET button.
Measurement mode
No.D-※S-OMA1021