○Mounting with panel mount adapter
●Mount part (a) to the front of the body and fix it. Then insert the body into the panel until (a) comes into
contact with the panel front surface.
Next, mount part (b) to the body from the rear of the panel and insert it until (b) comes into contact with
the panel where (b) is fixed.
•Panel mount adapter (Part No.: ZS-46-B)
Panel mount adapter + Front protective cover (Part No.: ZS-46-D)
: The panel mount adapter can be rotated through 90 degrees for mounting.
How to remove the panel mount adapter
●When removing the sensor monitor with panel mount adapter from the equipment, pull
it forward while opening up the hooks on both sides as shown in the figure below.
If the panel mount adapter is pulled forward without opening up the hooks, the sensor
monitor and the panel mount adapter may be damaged.
-16-
No.D-※S-OMA1021