SMC Networks D-MH1AD Series Operation Manual page 48

○Setting the line name input
<How to operate>
[F10] Press the UP or DOWN button in the sub display settings screen to display [Sub LinE].
Setting of the line name input
Press the UP or DOWN button to input a line name to display on the sub
display.
Press the SET button to make the next digit to the right flash and then
continue to input a line name.
(If the SET button is pressed at the last digit, the cursor returns to the first digit and the fist digit
starts flashing).
A total of eight digits can be input in the sub displays (left and right).
Characters are displayed in this order: A → b → ... → Y → (Z) → 0 → 1 → ... → 9 → symbols →
space.
(Characters which can be displayed are different for the 1st and 5th digits and other digits).
Keeping pressing both the UP and DOWN buttons adds or deletes a dot (decimal point).
Press and hold the SET button for 1 second or longer to make the entire set line name flash.
(At this point, the setting of the line name is not complete)
Press the SET button to save the setting.
•Characters which can be displayed for each digit are as follows.
(Display pattern of the 1st and 5th digits)
A to Z can be displayed. It is also possible to display the same display pattern as that for other digits.
(Display pattern for other digits)
Q, X and Z and some symbols (slash (/), asterisk ()) cannot be displayed.
"." (Dot) can be input after the 1st, 2nd, 3rd, 5th, 6th, and 7th digits.
Press the SET button.
[F10] Sub display (line name input) setup completed
-47-
Moves to the setting of line name input.
Returns to function selection mode.
No.D-※S-OMA1021